acid-drop

- Hacking the planet from a LilyGo T-Deck using custom firmware

git clone git://git.acid.vegas/acid-drop.git

Setup70b_ESP32_S3_ILI9341.h (1075B)

      1 // Setup for the ESP32 S3 with ILI9341 display
      2 // Note SPI DMA with ESP32 S3 is not currently supported
      3 #define USER_SETUP_ID 70
      4 // See SetupX_Template.h for all options available
      5 #define ILI9341_DRIVER
      6 
      7                     // Typical board default pins - change to match your board
      8 #define TFT_CS   34 //     10 or 34 (FSPI CS0) 
      9 #define TFT_MOSI 35 //     11 or 35 (FSPI D)
     10 #define TFT_SCLK 36 //     12 or 36 (FSPI CLK)
     11 #define TFT_MISO 37 //     13 or 37 (FSPI Q)
     12 
     13 // Use pins in range 0-31
     14 #define TFT_DC    7
     15 #define TFT_RST   6
     16 
     17 //#define TOUCH_CS 16 // Optional for touch screen
     18 
     19 #define LOAD_GLCD
     20 #define LOAD_FONT2
     21 #define LOAD_FONT4
     22 #define LOAD_FONT6
     23 #define LOAD_FONT7
     24 #define LOAD_FONT8
     25 #define LOAD_GFXFF
     26 
     27 #define SMOOTH_FONT
     28 
     29 // FSPI (or VSPI) port (SPI2) used unless following defined. HSPI port is (SPI3) on S3.
     30 //#define USE_HSPI_PORT
     31 
     32 //#define SPI_FREQUENCY  27000000
     33 #define SPI_FREQUENCY  40000000   // Maximum for ILI9341
     34 
     35 #define SPI_READ_FREQUENCY  6000000 // 6 MHz is the maximum SPI read speed for the ST7789V
     36 
     37 #define SPI_TOUCH_FREQUENCY 2500000