acid-drop

- Hacking the planet from a LilyGo T-Deck using custom firmware
git clone git://git.acid.vegas/acid-drop.git
Log | Files | Refs | Archive | README | LICENSE

Setup135_ST7789.h (2202B)

      1 // ST7789 135 x 240 display with no chip select line
      2 #define USER_SETUP_ID 135
      3 
      4 #define ST7789_DRIVER     // Configure all registers
      5 
      6 #define TFT_WIDTH  135
      7 #define TFT_HEIGHT 240
      8 
      9 #define CGRAM_OFFSET      // Library will add offsets required
     10 
     11 //#define TFT_RGB_ORDER TFT_RGB  // Colour order Red-Green-Blue
     12 //#define TFT_RGB_ORDER TFT_BGR  // Colour order Blue-Green-Red
     13 
     14 //#define TFT_INVERSION_ON
     15 //#define TFT_INVERSION_OFF
     16 
     17 // DSTIKE stepup
     18 //#define TFT_DC    23
     19 //#define TFT_RST   32
     20 //#define TFT_MOSI  26
     21 //#define TFT_SCLK  27
     22 
     23 // Generic ESP32 setup
     24 //#define TFT_MISO 19
     25 //#define TFT_MOSI 23
     26 //#define TFT_SCLK 18
     27 //#define TFT_CS    -1 // Not connected
     28 //#define TFT_DC    2
     29 //#define TFT_RST   4  // Connect reset to ensure display initialises
     30 
     31 // For NodeMCU - use pin numbers in the form PIN_Dx where Dx is the NodeMCU pin designation
     32 #define TFT_CS   -1      // Define as not used
     33 #define TFT_DC   PIN_D1  // Data Command control pin
     34 //#define TFT_RST  PIN_D4  // TFT reset pin (could connect to NodeMCU RST, see next line)
     35 #define TFT_RST  -1      // TFT reset pin connect to NodeMCU RST, must also then add 10K pull down to TFT SCK
     36 
     37 
     38 #define LOAD_GLCD   // Font 1. Original Adafruit 8 pixel font needs ~1820 bytes in FLASH
     39 #define LOAD_FONT2  // Font 2. Small 16 pixel high font, needs ~3534 bytes in FLASH, 96 characters
     40 #define LOAD_FONT4  // Font 4. Medium 26 pixel high font, needs ~5848 bytes in FLASH, 96 characters
     41 #define LOAD_FONT6  // Font 6. Large 48 pixel font, needs ~2666 bytes in FLASH, only characters 1234567890:-.apm
     42 #define LOAD_FONT7  // Font 7. 7 segment 48 pixel font, needs ~2438 bytes in FLASH, only characters 1234567890:.
     43 #define LOAD_FONT8  // Font 8. Large 75 pixel font needs ~3256 bytes in FLASH, only characters 1234567890:-.
     44 //#define LOAD_FONT8N // Font 8. Alternative to Font 8 above, slightly narrower, so 3 digits fit a 160 pixel TFT
     45 #define LOAD_GFXFF  // FreeFonts. Include access to the 48 Adafruit_GFX free fonts FF1 to FF48 and custom fonts
     46 
     47 #define SMOOTH_FONT
     48 
     49 
     50 // #define SPI_FREQUENCY  27000000
     51 #define SPI_FREQUENCY  40000000
     52 
     53 #define SPI_READ_FREQUENCY  20000000
     54 
     55 #define SPI_TOUCH_FREQUENCY  2500000
     56 
     57 // #define SUPPORT_TRANSACTIONS